TABLE OF CONTENTS


Unboxing

You will find the following items inside every bluebot box:


ItemQuantity
bluebot device1
10' USB-C power cable1
C-holders2
Ultrasonic coupling gel1
Replacement coupling pads6
Microfiber towel1
Sand paper disc1



Visual Guide


bluebot device

bluebot device

(ultrasonic water meter)

10' USB-C power cable

(10 feet long, creates a press-tight water resistant fit.)

C-Holders
(Hold the bluebot clamps open to replace pads)

Ultrasonic Coupling Gel & Pads

(Replacement Pads x6 and Gel are used as needed)

Microfiber Towel
(For removing dirt, dust and debris from the pipe before installation)
Sand Paper Disc
(For sanding away house paint, dirt, or grime on your pipe)

Maintenance Items

The silver c-holders located below the power cable box are used to prop the device clamps open. This is helpful during inspection and replacement of your ultrasonic pads. Six sets of replacement pads are also included. 


Installation Items

Below the bluebot device, you will find a square microfiber towel and a round sandpaper disc. During installation, we encourage you to install bluebot on a clean section of pipe for best results. Sanding away house paint, dirt, grime buildup, etc. from the pipe and cleaning with the microfiber cloth allows bluebot to have an even stronger ultrasonic signal at your location.


Special Use Items

The small tube of ultrasonic coupling gel is included for assistance in specific environments where bluebot is not producing a quality ultrasonic signal result. Most installations do not require the gel to be added and customers should not add gel unless instructed by bluebot support.




If you have any questions or would like to speak to a member of the bluebot team, contact us directly at hello@bluebot.com or call/text (831) 275-2715 M-F 10 AM - 6 PM PST.